| |
Restore Power and Performance with Newly Reformulated AMSOIL P.I. Gasoline Additive
 Newly reformulated AMSOIL P.I. (Performance Improver) provides unsurpassed fuel economy and performance. Today’s fuels vary in quality and additive treat levels. Although a certain level of detergent additive is required by law to be formulated into gasoline, cost restrictions cause refineries to use low quality additives in the lowest additive concentration (LAC), a level insufficient to prevent deposit accumulation. As a result, deposits accumulate on fuel injectors, intake valves and combustion chambers, often within just a few thousand miles, disrupting spray patterns, affecting electronic sensors and causing a multitude of problems.
The newly formulated AMSOIL P.I. Performance Improver is the most potent gasoline additive available today. As a concentrated detergent, it is unsurpassed in cleaning combustion chamber deposits, intake valve deposits and port fuel injector deposits, eliminating the need for expensive fuel injector cleaning procedures. The product is ideal for use prior to emissions inspections. It also helps maintain peak engine efficiency, fuel economy, power and drivability in newer low mileage engines. In engines with accumulated deposits, testing showed AMSOIL P.I. provided the following clean-up benefits after only one tank of gasoline:
• Improves fuel mileage an average of 2.3% and up to 5.7%
• Reduced emissions
~ hydrocarbons (HC) up to 15%
~ carbon monoxide (CO) up to 26%
~ nitrous oxides (NOx) up to 17%
• Restored power and performance
• Reduced need for costly higher octane fuel
• Reduced noise from carbon rap and pre-ignition
• Better drivability
• Smoother operation
Usage Recommendations: Treat one full tank of gas every 4,000 miles or 100 hours of service. One bottle treats 20 gallons of gas. Do not treat and run more than 40 gallons of gas per treatment. P.I. helps pass emissions tests. Treat gas, run that tank and fill up again prior to test. Safe for use with catalytic converters, oxygen sensors, oxygenated gas and 10% ethanol blended gas. Ideally, P.I. should be poured into the tank prior to filling it up with gas, but it will mix thoroughly when added after fill-up through normal agitation from driving.
See
More Product Information
About the Company: AMSOIL has been the recognized leader in synthetic lubrication since 1972. For more information about AMSOIL synthetic motor oils contact your nearest AMSOIL distributor, or call AMSOIL at (715) 392-7101 or 1-800-777-8491. AMSOIL INC., AMSOIL Building, Superior, WI 54880, or go to www.amsoil.com.
News Contact:
Ed Newman
Director of Advertising
Ph. 715-392-7101
enewman@amsoil.com
|