2004 Jeep Grand Cherokee 4.7L V8
AMSOIL Dual Remote By-Pass Filter (BMK-13)
Submitted by AMSOIL Dealer Larry C. Hansford

There is not enough room in the engine compartment to mount the Dual Remote By-Pass Filter (BMK-13) with the V8 engine, but there is a natural location on the front right frame rail, right behind the radiator. There is a bolt hole with a nut welded to the inside of the rail, which takes a 10mm X 150 bolt. (Photo 1)

I took a piece of 4"x4" angle iron, 4" long and drilled one leg to fit the bolt hole in the frame, and drilled the other leg to fit the 4 holes in the filter mount bracket, and bolted this to the frame after painting it. (Photo 2)

I then mounted the filter mount on this bracket, and connected the hoses to it. (Photo 3)

The filter adapter was installed, and the other end of the hoses were connected to it. (Photo 4)

The hoses run down under the radiator, along the sway bar, between the filter mount and the filter adapter. (Photo 5)

The final step was filling the filters with oil, and installing on the mount. (Photo 6) I selected the SDF-15 and BE-90 filters, rather than larger filters, since larger filters would have extended down below the bumper of the vehicle.

Photo 1	Photo 2
Photo 3	Photo 4
Photo 5	Photo 6

Back To By-Pass Filter Installation Index

By-Pass Parts Identification List

See the AMSOIL By-Pass Filter Main Product Page

Disclaimer: These installation examples have been submitted by sources independent of AMSOIL INC. and may not comply with AMSOIL INC. installation instructions or application recommendations.