BMK23 Installation and Servicing Instructions
The Ea By-Pass Oil Filter (EaBP) provides the best possible filtration protection against wear and oil degradation. Working in conjunction with the engine's full-flow oil filter,
the AMSOIL Ea By-Pass Filter operates by filtering oil on a "partial-flow" basis. It draws approximately 10 percent of the oil pump's capacity at any one time and traps the extremely small,
wear-causing contaminants that full-flow filters can't remove. The AMSOIL Ea Bypass Filter typically filters all the oil in the system several times an hour, so the engine continuously receives analytically clean oil.
AMSOIL EaBP Filters have an efficiency of 98.7 percent at two
microns. At normal operating RPMs the EaBP Filter will filter all of
the oil in a typical five quart sump in less than 10 minutes.
The superior construction of AMSOIL EaBP Filters provides better sealing
and increased longevity along with superior corrosion resistance.
AMSOIL EaBP Filters have a marine powder coated exterior; and
their zinc-dichromate base plates increase rust protection. EaBP
Filters have a nitrile HNBR gasket and an orange silicone anti-drain
valve. The two stage pleated and layered cellulose/full synthetic
media has an efficiency rating of 98.7 percent at two microns.
When used in conjunction with AMSOIL motor oil and an AMSOIL EaO or Donaldson Endurance™ filter, the EaBP90, 100 and 110 Filters should be changed every other full-flow filter change up to 60,000 miles or one year whichever comes first. When used with other brands of motor oil or full-flow filters, the EaBP Filter should be changed every other full-flow filter change. AMSOIL recommends using oil analysis when extending oil drain intervals.
AMSOIL recommends changing the EaBP120 every other full-flow filter change up to 90,000 miles or one year whichever comes first. Extended oil drain intervals should always be accompanied by an oil analysis program.
Increased Oil Capacity
The increased fluid system capacity and filtration
life provides improved oil cooling and ensures that
equipment constantly runs on clean oil. Engine efficiency
is increased, providing extended engine life.
AMSOIL has designed a high-efficiency
by-pass filter element that is also a soot removal
device. AMSOIL Ea By-Pass Filters use a synthetic/cellulose sandwiched media. The inner
layer of the element is composed of a highly efficient
cellulose media covered with a full synthetic
media outer layer. These filters remove 39 percent
of soot contaminants less than one micron.
Soot removal efficiency increases approximately
10 to 14 percent when the EaBP Filter is used in conjunction with a standard full-flow filter.
By-Pass Filtration Benefits
- Dramatically Extended Drain Intervals
- Improved Oil Cooling
- Increased Filtration Capacity and Life
- Increased Fluid System Capacity
- Efficient Small Particle and Soot Removal
- Significantly Extended Engine Life
- Equipment Constantly Runs on Clean Oil
- Increased Engine Efficiency
- Remove Particles Less Than One Micro
|If your equipment uses|
this AMSOIL Filter
|This is the thread used on that equipment|
|EAO11||M22 x 1.5|
|EAO15||3/4 - 16 UNF|
|EAO17||M22 x 1.5|
|EAO18||M22 x 1.5|
|EAO23||M18 x 1.5|
|EAO24||13/16 - 16UNS|
|EAO26||3/4 - 16 UNF|
|EAO34||3/4 - 16 UNS|
|EAO37||3/4 - 16 UNS|
|EAO38||3/4 - 16 UNS|
|EAO42||3/4 - 16UNF|
|EAO52||13/16 - 16UNS|
|EAO59||13/16 - 16UNS|
|EAO64||13/16 - 16UNS|
|EAO80||1 - 16UNF|
|EAO98||1 - 16UNF|
|EAO99||1 1/2 - 16UN|
|EA15K09||3/4 - 16UNS|
|EA15K10||3/4 - 16UNS|
|EA15K12||M20 x 1.5|
|EA15K13||M20 x 1.5|
|EA15K20||M20 x 1.5|
|EA15K29||M18 x 1.5|
|EA15K32||13/16 - 16UNS|
|EA15K50||M22 x 1.5|
|EA15K51||3/4 - 16 UNS|
|3/4" - 16||BK295|
|13/16" - 16||BK296|
|18mm x 1.5mm||BK297|
|20mm x 1.5mm||BK298|
|22mm x 1.5mm|
When ordering the BMK23:
- Spin-on Adapter BP402M is designed for 2008-Present Chevrolet 1500 & 2500 gas engines.
|1" - 16 (Cummins)||BK300|
|1-1/2" - 16 (Power Stroke 7.2 L)||BK301|
|13/16" - 16 (Duramax 6.6 L)||BK302|