Oil Change Kits from AMSOIL take the guesswork out of picking the best oil and filter combination for your vehicle.
Oil Grade: SEO84
Viscosity: |
10W-30 (-23 To 32°C) - SAE 10W-30 is preferred -23 C (-10 F) to -1 C (31 F); SAE 15W-40 is preferred above -1 C (31 F).
15W-40 (Above -12°C) - SAE 10W-30 is preferred -23 C (-10 F) to -1 C (31 F); SAE 15W-40 is preferred above -1 C (31 F). 5W-30 (Below 10°C) |
---|---|
Capacity: | 13.9 quarts (with filter). When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level. Top off to proper level as needed. |
Notes: | (1) In 2016 when the CK-4 standard was introduced, Ford superseded the original recommendation of ESE-M2C153-E with WSS-M2C171-F1. Ford Motor Company’s position on CK-4 engine oils is the following: Ford continues to recommend motor oils meeting the Ford specification WSS-M2C171-F1 instead of CK-4 motor oils in the 3.2L and 6.7L Ford diesel engines as well as older Ford diesel engines, 4.5L, 6.0L, 6.4L and 7.3L. Testing completed on some CK-4 type formulations have shown inadaquate wear protection compared to CJ-4 formulations developed and licensed before 2016. Therefore, Ford has included additional requirements beyond CK-4 in WSSM2C171-F1 to provide additional wear protection Like many other diesel engine manufacturers, with their own internal OEM specification, Ford is recommending oils that meet, Ford Material Engineering Specification WSS-M2C171-F1. |
1Based on third-party testing in the Detroit Diesel DD13 Scuffing Test for specification DFS 93K222 using 5W-30 as worst-case representation
Retail Price
1Based on third-party testing in the Detroit Diesel DD13 Scuffing Test for specification DFS 93K222 using 10W-30 as worst-case representation
Retail Price
1In accordance with industry-standard ISO SO 4548-12.
Retail Price
Retail Price
No recommendations available
No recommendations available
Capacity: | 22.7 quarts. |
---|
Retail Price
Retail Price
For Automatic Transmission: 4R70W....MA5
Notes: | (1) This specification has been updated from Mercon to Mercon V per TSB 06-14-4 |
---|---|
Capacity: | 5 quarts Initial Fill. |
Retail Price
Retail Price
Retail Price
For Automatic Transmission: E4OD....MA5
Notes: | (1) This specification has been updated from Mercon to Mercon V per TSB 06-14-4 |
---|---|
Capacity: | 6.4 quarts Initial Fill. |
Retail Price
Retail Price
Retail Price
For Manual Transmission: R2 (5-SPD)....MA5 All TEMPS....
Capacity: | 7.6 pints. |
---|
Retail Price
Retail Price
For Manual Transmission: S5-47 (5-SPD)....MA5 All TEMPS....
Notes: | (1) Synthetic blend Mercon V P/N XT-5-QSM |
---|---|
Capacity: | 6.8 pints. |
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Recommended For: HB
Notes: | (1) Hydraulic Brake Fluid, DOT 3 |
---|
Retail Price
For Transfer Case: BW1345....MLV
Notes: | (1) This specification has been updated from Motorcraft P/N XL-12 to Mercon LV. |
---|---|
Capacity: | BW1345 6.3 pints. |
Retail Price
Retail Price
For Transfer Case: BW1356E W/ PTO....MLV
Notes: | (1) This specification has been updated from Motorcraft P/N XL-12 to Mercon LV. |
---|---|
Capacity: | BW1356E With PTO 12.3 pints. |
Retail Price
Retail Price
For Transfer Case: BW1356E/BW1356....MLV
Notes: | (1) This specification has been updated from Motorcraft P/N XL-12 to Mercon LV. |
---|---|
Capacity: | BW1356E/BW1356 4 pints. |
Retail Price
Retail Price
GL-5 All TEMPS....75W-90
Capacity: | Front 5.9 pints. |
---|
Retail Price
Retail Price
Retail Price
Standard Differential, Dana 70-2U....GL-5 All TEMPS....80W-90
Capacity: | Dana 70-2U Rear 6.6 pints. Fill to no more than 1/4 to 9/16 inch below fill plug hole. |
---|
Retail Price
Retail Price
Retail Price
Standard Differential, Dana 80....GL-5 All TEMPS....75W-140
Notes: | (1) Synthetic oil is required. |
---|---|
Capacity: | Dana 80 Rear 8.5 pints. Fill to no more than 1/4 to 9/16 inch below fill plug hole. |
Retail Price
Standard Differential, Ford 10.25 RG....GL-5 All TEMPS....75W-140
Notes: | (1) Synthetic oil is required. |
---|---|
Capacity: | Ford 10.25 RG Rear 7.4 pints. Fill to the bottom of fill hole. |
Retail Price
Limited Slip Differential, Dana 70-2U....GL-5* All TEMPS....80W-90
Capacity: | Dana 70-2U Rear 6.6 pints. Fill to no more than 1/4 to 9/16 inch below fill plug hole. |
---|
Retail Price
Retail Price
Retail Price
Limited Slip Differential, Dana 80....GL-5* All TEMPS....75W-140
Capacity: | Dana 80 Rear 8.5 pints. Fill to no more than 1/4 to 9/16 inch below fill plug hole. |
---|
Retail Price
Limited Slip Differential, Ford 10.25 RG....GL-5* All TEMPS....75W-140
Notes: | (1) Add 8 oz. (236 ml) of Additive Friction Modifier XL-3 or equivalent formulated to meet Ford Spec EST-M2C118-A for complete refill of limited slip axles. |
---|---|
Capacity: | Ford 10.25 RG Rear 7.4 pints. Fill to the bottom of fill hole. |
Retail Price
Recommended For: HB
Notes: | (1) Motorcraft High Performance DOT 3 brake fluid, P/N PM-1-C or equivalent meeting Ford specification WSS-M6C65-A1. |
---|
Retail Price
Recommended For: MA
Notes: | (1) Per TSB 07-1-7 Mercon V can now be used to service power steering systems in which the original recommendation was Mercon |
---|
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
*All trademarked names are the property of their respective owners and may be registered marks in some countries. No affiliation or endorsement claim, express or implied, is made by their use.
1Fuels tested in 2017.
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
Retail Price
AMSOIL synthetic lubricants are the solution for drivers who want the most from their 1997 Ford F250 HD PICKUP. How good are they? Our synthetic motor oils blow the doors off the highest industry standards.
Protect your Ford F250 HD PICKUP in any driving condition with our specially formulated motor oils. Whether it’s extreme temperatures, long commutes, towing, hauling, the added stress of a turbocharger or you’re simply extending the time between oil changes, our motor oils will keep your 1997 Ford F250 HD PICKUP protected.
We produce the synthetic motor oil, oil filter, transmission fluid, gear lube and grease for a complete fluid change – everything to keep your Ford F250 HD PICKUP running smoothly for the long haul.
AMSOIL products are subjected to rigorous third-party, industry-standard testing so you can rest assured you’re getting maximum protection. Also, check out our customer reviews on amsoil.com to make the best choice for your Ford F250 HD PICKUP. Hear from more than 6,000 customers who have experienced AMSOIL lubricants.
Using a properly formulated transmission fluid for your Ford F250 HD PICKUP can protect your vehicle from costly problems down the road. AMSOIL transmission fluids offer the best protection for your Ford F250 HD PICKUP, even in the most severe driving conditions. Protect your vehicle’s transmission from wear, sludge and temperature-related problems and drive with confidence.
Shop online and get your products in 3 business days or less. With free shipping on orders over $100, and an average 25% savings for Preferred Customers, shopping online is the fastest way to get AMSOIL products to your doorstep. Becoming a Preferred Customer earns you savings, points on purchases and more. Simply shop amsoil.com and add a P.C. membership to your cart before checking out. You will receive an immediate savings on products for your 1997 Ford F250 HD PICKUP.
Getting products for your 1997 Ford F250 HD PICKUP couldn’t be easier. Find a nearby Independent AMSOIL Dealer or retailer using the AMSOIL Locator.
Specifications contained on this website are based on manufacturers' information and were believed accurate at the time of publication. Our recommendations apply to AMSOIL products only, as we cannot be responsible for products from other manufacturers. Always compare fluids and lubricants that were installed in the vehicle with those replacing them during service. Never install more fluid or lubricant than what is considered adequate according to gradients on dipstick or level of filler hole. Fill and drain locations are for reference only. Failure to perform adequate inspections or obtain proper resolution will limit or negate any liability toward AMSOIL INC. Models introduced midyear may not have the same specifications as those produced earlier.
If any discrepancies are noted, they can be simply reported to AMSOIL by clicking on the "Problem?" link docked to the left. We review all reported problems, if you would like a personal response to the issue you are reporting please enter your email address in the space provided on the form.